Kit Assembly - Metra 99-9714WR Instrucciones De Instalación

ISO DIN radio provision
1. Secure the radio brackets to the radio
housing with (4) #8 x 3/8" Phillips
screws supplied. (Figure A)
2. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the radio housing
assembly and secure with screws
supplied with the radio. (Figure B)
4. Insert the LCD screen into the radio
housing, route the cable through the
LCD back plate, and then secure to the
radio housing assembly using (2) #8
x 3/8" screws supplied with the kit.
(Figure C)
5. Secure the radio housing assembly to
the bike using (4) 3/16 Allen screws
previously removed in step 8 of
disassembly. (Figure D)

KIT ASSEMBLY

(Figure A)
(Figure B)
6. a. For the Street Glide, Electra Glide,
Ultra, and Limited models 2014-Up:
Attach the radio bracket removed
in step 6 of disassembly to the top
of the radio housing assembly, and
secure with (4) #10-32 x 1/2" Phillips
steel machine screws supplied.
b. For the Road Glide 2015-Up:
Attach the fairing bracket removed
in step 10 of disassembly to the top
of the radio housing assembly, and
secure with (4) #10-32 x 1/2" Phillips
steel machine screws supplied.
Ensure the bracket is far forward,
and the curved portion is facing the
rear of the bike as mentioned in
disassembly.
Continue to Axxess Interface Installation
(Figure C)
(Figure D)
REV. 9/11/2020 INST99-9714WR
5