Pre-Wiring Instructions; Wiring Instructions - Metra 99-9714WR Instrucciones De Instalación

PRE-WIRING INSTRUCTIONS

Perform the following steps for each interface.
1. Push the harness into the cap.
2. Connect the harness to the circuit board, then clip it onto the circuit board enclosure.
Note: Make sure the harness labeled "ASWC" goes onto the circuit board enclosure labeled "ASWC"
3. After the interface has been programmed and tested, install the cover onto the opening of the housing.

WIRING INSTRUCTIONS

From the 99-9714WR harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire. (If the aftermarket radio has no illumination
wire, tape off the Orange wire).
• Connect the White wire to t he left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
WIRING INSTRUCTIONS
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the ASWC-1 (provided) to retain handlebar audio controls.
Please note that "handlebar control" is also referred to as "steering wheel control".
• For the radios listed below: Connect the 3.5mm adapter to the male 3.5mm jack from the
ASWC-1 harness. Any remaining wires tape off and disregard:
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire of the connector. Then connect the remaining steering wheel control wire, normally
Brown/White, to the Brown wire of the connector.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire
to the Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to
Kenwood. See the instructions under changing radio type.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining steering
wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire of the
connector. If the radio comes with a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the manual
provided with the radio for assigning the SWC buttons. Contact the radio manufacturer for
more information.
• For all other radios: Connect the 3.5mm jack into the jack on the aftermarket radio
designated for an external steering wheel control interface. Please refer to the aftermarket
radios manual if in doubt as to where the 3.5mm jack goes to.
(CONT)
REV. 9/11/2020 INST99-9714WR
7