Insights - Advanced Menu; Change Parameters - Key Automation CT-PAE Instrucciones Y Advertencias Para Su Instalación Y Uso

EN

6 - INSIGHTS - ADVANCED MENU

6.1 - Change parameters

Holding down the M button for at least 2 seconds until you hear a
beep displays and allows for editing of the following operating
parameters:
Function Default
1. 650
2. 240
3. 25
4. 20
5. 8
6. 3
7. 200
8. 100
9. 10
A. 2
B. 75
C. 0
D. 0
E. 0
F. 0
G. 0
H. 1
J. 15
L. 0
N. 0
O. 0
P. 0
R. 0
T. 0
U. 0
Y. 0
To change a parameter, operate +and- then save holding down the OK button for at least 2 seconds until you hear a beep.
Holding down the M button for at least 2 seconds until you hear a beep shows the viewing mode again.
28
Min Max Value
100 700 Opening speed (mm/sec)
100 600 Closure speed (mm/sec)
1 30 Opening deceleration speed (mm/sec)
1 30 Closure deceleration speed (mm/sec)
2 50 Opening brake
2 50 Closing brake
50 300 Approach space at opening
50 300 Approach space at opening
1 100 Force on obstacle
1 60 Pause time (sec)
Percentage of partial opening run (1 to
50 99
100%)
0 15 Card Address (0 to 15)
0 1 Safety elastic
0 2 If door is forced (Pull & Go)
0 4 If there is power outage
If battery is dead
0 4
(can be displayed only if parameter P=1)
0 1 Direction of motion( )
0 59 Voltage applied when door stopped
0 2 FOTO Surveillance
0 2 FOTO RALL Surveillance
0 2 STOP Surveillance
0 1 Battery Test
0 1 Lock if R.INT or R.EXT
Sixth manual selector position
0 1
(LOGO KEY)
0 9 Duration opening START
0 1 Interlock
Please note: The function change from 1 to 9 involves the performingof
2 cycles of self-regulation during which the display shows "
0 = not present
1 = present
0=resistance to force
1 = opens
2 = stays open
0 = functioning continues
1=opens even if locked
2=closes and locks
3=opens only if unlocked
4=closes but does not lock
0 = functioning continues
1=opens even if locked
2=closes and locks
3=opens only if unlocked
4=closes but does not lock
0=right hand opening
1=left hand opening
N.B. Check hook dragging carts
mechanical part
0 = not monitored
1=one monitored device
2=two monitored devices
0 = not monitored
1=one monitored device
2=two monitored devices
0 = not monitored
1=one monitored device
2=two monitored devices
0 = test disabled
1 = test enabled
0 = Normal functioning
1= RINT or REXT closed door locks
0 = Partial opening
1=REXT(external radar active)
0 = step-step
1 to 9 (in tens of seconds)
0 = disabled
1 = enabled
"