Worx WX169L Manual De Instrucciones página 10

5. TWO-SPEED GEAR CONTROL
(See Fig. E)
The drill has a Two-Speed Gear Control (3)
designed for drilling or driving at LO (mark is
1) or HI (mark is 2) speeds. A slide switch is
located on top of the drill to select either LO
or HI speed. When using the drill in the LO
speed range, the speed will decrease and the
drill will have greater power and torque. When
using the drill in the HI speed range, the speed
will increase and the drill will have less power
and torque.
Gear I
Low speed range: for screwdriving or working
with large drilling diameter
Gear II
High speed range: for working with small
drilling diameter
WARNING: To prevent gear damage,
always allow the chuck to come
to a complete stop before changing the
direction of rotation.
6. CHUCK ADJUSTMENT (See Fig. F)
10
With the chuck facing you, rotate the chuck
counterclockwise to open the jaws. Insert the
drill bit between the chuck jaws. Rotate the
chuck clockwise to tighten the jaws. Insure
that the drill bit is seated in the center of the
jaws.
7. TORQUE ADJUSTMENT (See Fig. G)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the Torque
Adjustment Ring (2). The torque is greater
when the Torque Adjustment Ring is set on
a higher setting. The torque is less when the
Torque Adjustment Ring is set on a lower
setting.
Make the setting as follows:
1 - 4 for driving small screws
for driving screws into soft
5 - 9
material
for driving screws into soft and
10 - 15
hard material
for heavy drilling
20V Cordless Drill / Driver
8. AUTOMATIC SPINDLE LOCK
(See Fig. H)
The automatic spindle lock allows you to use
it as a regular screwdriver. You can give an
extra twist to firmly tighten a screw, loosen
a very tight screw or continue working
when the battery energy has expired. For
manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
9. USING THE LED LIGHT
The LED light allows you to keep a clear view
under less illuminated circumstances. To turn
on the light, press the On/Off switch and make
sure the Forward/Reverse Rotation Control is
on right/left position. When you release the on/
off switch, the Light will go off.
The LED Light is also a battery capacity
indicator. It will flash when power gets low.
10. DRILLING
When drilling into a hard smooth surface,
use a center punch to mark the desired hole
location. This will prevent the drill bit from
slipping off center as the hole is started. Hold
the tool firmly and place the tip of the bit at
the point to be drilled. Depress the switch
trigger to start the tool. Move the drill bit into
the workpiece, applying only enough pressure
to keep the bit cutting. Do not force or apply
side pressure to elongate a hole.
Tungsten carbide drill bits should
always be used for concrete and
masonry. When drilling in metal, only use
HSS drill bits in good condition. Always
use a magnetic bit holder (not included)
when using short screwdriver bits. When
screw-driving, apply a small quantity
of liquid soap or similar to the screw
threads to ease insertion.
11. DISPOSAL OF AN EXHAUSTED
BATTERY PACK
To preserve natural resources, please
recycle or dispose of the Battery Pack
(7) properly. This Battery Pack contains
Lithium batteries. Consult your local waste
authority for information regarding available
recycling and/or disposal options. Discharge
your Battery Pack by operating your drill, then
EN