Worx WX169L Manual De Instrucciones página 8

identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
ADDITIONAL SAFETY
RULES FOR YOUR
CORDLESS DRILL
1. Use auxiliary handles supplied with
the tool. Loss of control can cause
personal injury.
2. Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden
wiring. Cutting accessory contacting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock.
GENERAL SAFETY
WARNINGS FOR BATTERY
PACK
8
1) WARNING: Risk of fire and
burns. Do not disassemble, heat
above 100°C (212°F), or incinerate.
Do not expose cells or batteries to
heat or fire. Avoid storage in direct
sunlight.
2) Dispose of used batteries promptly
according to local recycling or waste
regulations.
3) Dispose of used battery promptly. Do
not dispose of in fire.
4) Keep battery out of reach of children
and in original package until ready to
use.
5) Never put batteries in mouth. If
swallowed, contact your physician or
local poison control center.
6) CAUTION – The battery used in
this device may present a risk of
fire or chemical burn if mistreated.
Replace battery with (ROCKWELL
16V) only. Use of another battery
may present a risk of fire or
explosion
20V Cordless Drill / Driver
7) WARNING: Do not use a visibly
damaged battery pack or
appliance as applicable.
8) WARNING: Do not modify or
attempt to repair the appliance
or the battery pack as applicable.
9) BATTERY MUST BE RECYCLED.
10) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire when
used with another battery pack.
11) Do not short-circuit a cell or battery.
Do not store cells or batteries
haphazardly in a box or drawer where
they may short-circuit each other
or be short-circuited by conductive
materials.
12) Do not subject cells or batteries to
mechanical shock.
13) Keep cells and batteries clean and
dry. Wipe the cell or battery terminals
with a clean dry cloth if they become dirty.
14) Secondary cells and batteries need to
be charged before use. Always refer
to the cell or battery manufacturer's
instructions and use the correct
charging procedure.
15) Do not maintain secondary cells and
batteries on charge when not in use.
16) Retain the original cell and battery
literature for future reference.
17) When disposing of secondary cells
or batteries, keep cells or batteries
of different electrochemical systems
separate from each other.
18) Use only the cell or battery in the
application for which it was intended.
EN