Show Rds Information; Troubleshooting; Technical Specification - Sharp XL B710 Manual De Usuario

8
3. Press the PROG button to store the station.
4. Repeat above steps 1 to 3 for each station you want to store in
memory with a preset number.

Show RDS information

RDS (Radio Data System) is a service that allows FM stations to show
additional information. If you tune to a RDS station, the station name
are displayed. When automatic programming is used, RDS stations are
programmed fi rst.
1. Tune to a RDS station.
2. Press the INFO button repeatedly to scroll through the following
information (if available): Station name, PTY, RADIO TEXT, Frequency,
CLOCK INFO.

Troubleshooting

No Power
Reason
• Power cable not connected to wall socket
• Power socket is not switched on
Solution
• Make sure the plug is connected
• Switch the power on
No Sound CD/AUX/RADIO
No Sound from AUX input
Reason
• Volume is too low
• AUX source volume is too low
Solution
• Increase the volume
• Increase the output volume of the AUX source
Sound is distorted
Sound is distorted from AUX Input
Reason
• Volume is too high
• AUX source volume is too high
Solution
• Reduce the volume
• Reduce the output volume of the AUX source
Unable to play CD
Reason
• No disc in the tray
• Disc not loaded properly
• Disc is dirty
Solution
• Insert a compatible disc
• Check the disc loaded
• Clean the disc
Static Sound
Reason
• Poor reception
Solution
• Re-locate the antenna (FM)
Desired station not found
Reason
• Weak signal
• Station not available in your area
Solution
• Use the manual tune function
Clock settings erased
Reason
• Power has been interrupted or the power cord has been disconnected.
Solution
• Reset the clock.
Unit cannot synchronise the RDS station's time and date
Reason
• The station does not transmit the time and date information.
Solution
• Setting the time synchronisation to "Radio"- see point set the clock.
I can't fi nd the Bluetooth name of this unit on my Bluetooth device
Reason
• Bluetooth function is deactivated on your device
Solution
• Ensure the Bluetooth function is activated on your Bluetooth device.
• Re-pair the unit with your Bluetooth device.
Technical specifi cation
Model
Radio Signal
Power Supply
Power Consumption
Standby power consumption
Output Power
Frequency Response
Bluetooth
Version
Maximum power transmitted
Frequency bands
CD player
Disc format
Remote Control
Battery Type
XL-B710
87.5-108MHz
AC 220-240V ~ 50Hz
30 W
<1W
2 x 15 W (RMS)
60Hz - 20KHz
V 4.2
<20 dbm
2402 MHz ~ 2480 MHz
CD, CD-R, CD-RW, MP3
CR2025
110 mm
2,8 kg