Environmental Protection - Narex ASR 14 ES Instrucciones De Uso Originales

(Classes of strengths of bolts and nuts pursuant to EN 20 898-1)
(Nm)
250
200
150
100
50
0 1 2 3 4
t (s) M8
1 60 Nm
2 65 Nm
3 70 Nm
4
75 Nm
5
80 Nm
6
85 Nm
7 90 Nm
8 95 Nm
9 100 Nm
10 100 Nm
The requested time of tightening is determined roughly by the attached
diagram.
The tightened parts have to be checked individually, case by case, depend-
ing on their kind. Acting of strokes longer than 10 seconds does not affect
increase of the torque anyhow,
Screws of smaller sizes may be tightened by the soft connection only; time of
tightening must be shorter than 1 s not to damage the screws.
When using torque bars, the screws from the M8 size can be tightened.
If high load has to be applied on the bolted joint for a longer time period, e.g.
loosening of excessively tightened or rusted screws, the machine has to be
unloaded regularly and the mechanism cooled by the idle run!
Maintenance
Instructions for device cleaning
Start the motor and blow impurities and dust out of the vent holes of the
device. Use protective goggles for this operation. Clean the external plastic
parts by a wet rag and mild detergent. Though these parts are made of the
materials resistant to solvents, NEVER use any solvent.
Instructions for cleaning the charger
Impurities and dust can be removed from external charger surfaces by a rag
or a non-metal brush. Use neither water nor detergents.
WARNING!!
Prior to start cleaning, disconnect the charger from the power supply.
Accessories
The accessories recommended for use with the device are available commer-
cially in the shops with hand el. tools.
Storage
The packed device can be stored in a dry unheated store room where the
temperature does not drop below -5 °C.
Store the unpacked device in a dry store room where the temperature does not
drop below +5 °C and where abrupt temperature changes are prevented.

Environmental protection

El. tools, accessories and packaging should be collected for subsequent re-
covery, recycling and environmentally sound disposal.
For EU countries only:
Do not dispose the el. tools as the home waste!
In conformity with the European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation in national legislations the
unusable dismantled el. tools should be collected for subsequent recovery,
recycling and environmentally sound disposal.
M16
M12
M10
5 6 7 8 9 10
M12 M16
90 Nm 100 Nm
100 Nm 120 Nm
110 Nm 140 Nm
120 Nm 160 Nm
130 Nm 170 Nm
140 Nm 180 Nm
150 Nm 190 Nm
160 Nm 200 Nm
160 Nm 200 Nm
160 Nm 200 Nm
Warranty
We grant warranty for material or workmanship defects of our devices in con-
formity with mandatory provisions of the relevant country, but 12 months as
a minimum. The warranty period of 24 months is valid in the EU countries
in case of the exclusively private scope of use (proved by invoice or delivery
note).
There is a 6-months warranty for battery cell.
The damages following from natural wear, overloading, incorrect handling
and/or the damages caused by the user or by using the device contrary to
the operating manual or the damages known upon purchase are excluded
from the warranty.
The complaints can be admitted only if the device is sent back to the supplier
or to the Authorized Service Center NAREX in the non-dismantled state. Keep
(s)
the operating manual, safety instructions, list of spare parts and proofs of
purchase safely. Otherwise the current warranty conditions and terms of the
manufacturer are always valid.
Information about noise level and vibrations
The values have been measured in conformity with EN 60745.
Weighed sound pressure level L
Weighed sound power level L
In accuracy of measurements K = 3dB (A).
Use the noise protection device!
Weighed level of arm affecting vibrations is 22.0 m/s
In accuracy of measurements K = 1.5 m.s
Certificate of Conformity
ASR 14 ES:
We declare that the device meets requirements of the following standards
and directivesc.
Safety:
EN 60745–1; EN 60745–2–2
Directive 2006/42/EC
Electromagnetic compatibility:
EN 55014–1; EN 55014–2
Directive 2004/108/EC
2009
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Certificate of Conformity
AN-UNI:
We declare that the device meets requirements of the following standards
and directivesc.
Safety:
EN 60335–1; EN 60335–2–29
Directive 2006/95/EC
Electromagnetic compatibility:
EN 55014–1; EN 55014–2;EN 61000–3–2; EN 61000–3–3
Directive 2004/108/EC
2009
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Changes are reserved
English
is 96 dB(A).
pA
is 103 dB(A).
wA
2 .
-2 .
Antonín Pomeisl
CEO of the company
29. 12. 2009
Antonín Pomeisl
CEO of the company
29. 12. 2009
15