Maintenance And Service; Environmental Protection - Narex ASR 18-S Instrucciones De Uso Originales

English
ASR 18 HT-S:
M (Nm)
800
600
400
200
1 2 3 4 5
Based on the type of tightened parts, each combination of materi-
als must be tested separately. The effect of impact action exceed-
ing 10 seconds has no influence on the increase of the tightening
torque.
Screws of smaller sizes may be tightened at soft joint only,
whereas the tightening time may be even shorter than 1 sec-
ond. The impact action time should not exceed 2–3 seconds
in these cases.
While loosening screw joints (rusty screws etc.) even the max.
impact action time (10 seconds) may not be sufficient enough. In
such a case the impact mechanism should be allowed to act on and
off at cycles of about 10 seconds of impact action/ 10 seconds of
idle run to let the machine cool down.

Maintenance and service

Instructions for device cleaning
Start the motor and blow impurities and dust out of the vent holes
of the device. Use protective goggles for this operation. Clean the
external plastic parts by a wet rag and mild detergent. Though
these parts are made of the materials resistant to solvents, NEVER
use any solvent.
Instructions for cleaning the charger
Attention! Risk of electric shock. Prior to start han-
dling the charger, disconnect the line plug from the
socket!
Impurities and dust can be removed from external charger surfaces
by a rag or a non-metal brush. Use neither water nor detergents.
Attention! With respect to protection from el. shock
and preservation of the class of protection, all mainte-
nance and service operations requesting jig saw case
removal must be performed by the authorized service centre
only!
The current list of authorized service centres can be found at our
website www.narex.cz, section "Service Centres".
22
M24
M20
M16
M12
t (sec.)
6 7 8 9 10
Accessories
The accessories recommended for use with this device are availa-
ble commercially in the shops with hand el. tools.
Storage
The packed device can be stored in a dry unheated store room
where the temperature does not drop below –5 °C.
Store the unpacked device in a dry store room where the temper-
ature does not drop below +5 °C and where abrupt temperature
changes are prevented.

Environmental protection

El. tools, accessories and packaging should be collected for sub-
sequent recovery, recycling and environmentally sound disposal.
For EU countries only:
Do not dispose the el. tools as the home waste!
In conformity with the European Directive 2002/96/EC on waste
electrical and electronic equipment and its implementation in
national legislations the unusable dismantled el. tools should be
collected for subsequent recovery, recycling and environmentally
sound disposal.
Warranty
We grant warranty for material or workmanship defects of our
devices in conformity with mandatory provisions of the relevant
country, but 12 months as a minimum. The warranty period of 24
months is valid in the EU countries in case of the exclusively private
scope of use (proved by invoice or delivery note).
There is a 6-months warranty for battery cell.
The damages following from natural wear, overloading, incorrect
handling and/or the damages caused by the user or by using the
device contrary to the operating manual or the damages known
upon purchase are excluded from the warranty.
The complaints can be admitted only if the device is sent back
to the supplier or to the Authorized Service Center NAREX in the
non-dismantled state. Keep the operating manual and proofs of
purchase safely.
Otherwise the current warranty conditions and terms of the man-
ufacturer are always valid.