Care And Cleaning - Kohler K-9530 Guía De Instalación Y Cuidado

Complete the Diverter Installation (cont.)
While supporting from below, carefully install and wrench tighten
the cartridge assembly into the diverter body.
Install the diverter handle. Use a hex wrench to tighten the
setscrew.
Assemble the adapter to the cartridge; tighten the setscrew to
secure.
Press the handle onto the adapter.
6. Installation Checkout
Complete the installation of the valve, valve trim and any other
components according to the instructions packed with the
product.
Ensure all connections are tight.
Open the drain.
Turn on the main water supply and check for leaks. Repair as
needed.
Open both hot and cold valves and run water through the spout
(if installed) to remove debris. Check for leaks.
Confirm proper diverter operation.
Turn the valves to the closed position.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Do not allow cleaners to sit or soak on the surface.
Kohler Co. 11 1229813-2-A