EdilKamin MAXIMA 14 Manual De Instalación, Uso Y Mantenimiento página 89

Press the key to move to the next setting, press the ESC
key repeatedly to return to the HOME screen.
Duration of display brightness
This adjusts the time after which, if no key is pressed, the dis-
play brightness returns to that of stand-by mode.
Adjust this setting with the + and - keys.
The minimum setting is 5", the maximum is 60", the factory
setting is 30".
" B A C K L I G H T D U R A T A
R E T R O I L L . =
D U R A T I O N " = 3 0
ESC
Press the key to move to the next setting, press the ESC
key repeatedly to return to the HOME screen.
Correcting the temperature measurement
The internal temperature sensor is carefully calibrated and ac-
curately checked in the factory.
However, if the position and location of the console does not
allow for correct and precise measurement of the environmental
temperature, the temperature detected by the sensor inside the
console can be re-calibrated.
Change the set value with the + and - keys
The minimum setting is -5.0°C, the maximum is +5.0°C, the
factory setting is 0.0°C.
" T E M P R E A D I N G C O R R E Z I O N E
M I S U R A T E M P .
C O R R E C T I O N " = 0 . 0 °
0 . 0 °
ESC
Press the key to move to the next setting, press the ESC
key repeatedly to return to the HOME screen.
Firmware version (fw) only for technical assistance centre
This lets you check the version of the fi rmware in the console.
V E R S I O N F W = X . X
V E R S I O N E
X . X
ESC
INSTRUCTIONS FOR USE
3 0
=
F W =
- 89
Technical menu
This menu is exclusively for use by the technical assistance
centre.
REMOTE CONTROL OF THE BOILER
The fi rst line of the HOME screen shows the temperature, in
real time, of the output water produced by the boiler.
The second line shows the SET temperature of the output water
set by the user.
The third line shows the working power automatically chosen
by the boiler.
The fourth line shows the state of the boiler, which can be in
stand-by, ignition, on, during shut-down, off, or blocked.
Switching the boiler on and off
To switch the boiler on/off, proceed as follows: from the
HOME screen press any key and then the menu key, select
BOILER and confi rm the selection with the enter key
C O N S O L E
B O I L E R
C A L D A I A
ESC
Go to the BOILER STATUS screen, press the ON key to switch
it on or the OFF key to switch it off.
B O I L E R S T A T U S
S T A T O C A L D A I A
S T A N D - B Y
S T A N D - B Y
ESC
-
.
=
ON OFF