Worx landroid WR140 El Manual Del Propietario página 34

Quick reference
Upside down! Press START to
reset.
Mower trapped! Press START to
reset.
Mower lifted! Press START to reset.
Battery voltage too low! Please
change battery.
Wire missing! Press START to reset. Machine can't find boundary wire signal. If the LED light is red, check if the
Battery temperature out of range!
Please wait.
34
This could have happened when
Landroid came into contact with a
sloping surface which made it overturn.
Landroid is trapped.
Landroid is lifted up.
Battery exausted.
Temperature is too high (more than
131°F) when charging.
Turn Landroid upright and remove any
obstacle that might have caused
Landroid to overturn.
Turn power off.
Take Landroid to an area of your lawn
free of obstacles, then turn power on.
Press start.
If the error message is still displayed:
turn power off, turn Landroid
upside-down. Check if there is anything
preventing the wheels from rotating.
Remove any obstruction, turn the
Landroid upright, turn power on.
Turn power off.
Take Landroid to an area clear of
obstacles, turn power on. Press start.
If the error message is still displayed:
turn power off, turn Landroid
upside-down and check there's anything
that can cause Landroid to be lifted up.
Remove any possible object, turn
Landroid upright, turn power on.
In this case you must turn Landroid off
and place it in the charging base, then
'Emergency charging' will be displayed
and it will start charging.
If the battery error still persist, your
battery is damaged and need to be
changed.
boundary wire is well connected to the
clamps on the charging base.
If the problem persists, check that the
boundary wire hasn't been cut.
Place the charging base in a shady area
or wait until the temperature has cooled
down.
EN