Trouble Shooting - Worx landroid WR140 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Quick reference

TROUBLE SHOOTING

If your Landroid does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer Service.
SYMPTOM
The LED light on the charging base
does not turn on.
Red light on the charging base.
Landroid turns on, but the blade
disc does not spin.
Landroid vibrates.
Grass is being cut unevenly.
Your Landroid is inside its working
area and the boundary wire is
connected, but the display says
'Outside working area! Press START
to reset'
36
CAUSE
There is no power.
The boundary wire isn't connected.
Landroid is searching for the charging
base.
The blade disc is unbalanced.
Blades may be damaged.
Landroid does not work enough hours
per day to cut the grass.
Mowing area is too big for the size of
Landroid you have.
The blades are dull and not sharp.
The cutting height is set too low for the
length of the grass.
Grass or another object has wrapped
around the blade disc.
There is a build-up of grass in the blade
disc or motor frame box.
The boundary wire ends are clamped
incorrectly.
SOLUTION
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Check that the boundary wire has been
connected correctly to the charging
base. Check there are no breaks in
the boundary wire.
This is normal: when Landroid needs to
recharge, the blade disc does not rotate
while it is searching for the charging
base automatically.
Check the blades and replace them if
damaged.
Remove debris and foreign objects from
the blades and blade disc.
Try adding more hours to the mowing
schedule.
Try decreasing the size of the mowing
area.
Change all the blades and screws in
order to balance the blade disc.
Raise the cutting height and then
gradually lower.
Check the blade disc and remove any
grass or other objects that might
prevent it spinning.
Make sure the blade disc rotates easily.
If need be, you may take off the blade
disc and then remove the debris.
Reverse the boundary wire ends and
reconnect to the charging station.
EN

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Landroid wr143Landroid wr150Landroid wr153

Tabla de contenido