Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USER'S MANUAL. PROLITE-40
8
SETTING WORKING MODE AND PARAMETER
8.1
Setting working mode
The working mode of PROLITE-40 Fusion Splicer are automatic operation and
manual operation. The operations are as follows:
1.- Press
to enter the first class menu.
2.- Press
or
3.- Press
or
4.- Press
to confirm.
5.- Press
to exit the first class menu, then working mode will be displayed on the
screen.
NOTE:
1) Auto operation and manual operation can't be mixed.
2) Best to press
3) The fusion splicer won't estimate loss when it's manual operation.
8.2
Setting working parameter
Working parameters of PL-40 include heating time, surface-angle, tension test,
etc. The operations are as follows:
1.- Press
to enter the first class menu.
2.- Press
or
3.- Press
or
4.- Press
to confirm.
5.- Press
to exit the first order menu.
02-2011
to make cursor point to working mode to be selected.
to select working mode.
to setting gap when it's manual operation.
to make cursor point to working parameter to be selected.
to select needed working parameter.
Page 33
Publicidad
Capítulos
Tabla de contenido
