Appendix C: Unusual Condition, Confirmation And Solution - Promax PROLITE-40 Manual De Instrucciones

USER'S MANUAL. PROLITE-40
12 APPENDIX C: UNUSUAL CONDITION,
CONFIRMATION AND SOLUTION
Unusual condition
1.- After opening 1.
the machine, the
screen doesn't
have light; After
2.
opening the
windshield, the
3.
light is off (the
machine doesn't
4.
have reaction)
2.- After closing the 1. The windshield is not
pressed well or the fiber
windshield, the
image of fiber is didn't come into the V-
dim. groove.
3.- When pressing 1. The length of cutting
fiber is wrong.
to setting gap,
2. The fiber holder doesn't
fiber moved from
work well.
front to behind
Then "Reload fiber"
is displayed.
4.- When pressing 1. There is dust on the lens
or the light.
to setting gap,
2.
fiber moved to
reflector.
behind, then
"Reload fiber" is
displayed or fiber
moved from left to
right , occasionally
it can splice.
02-2011
Unusual condition, confirmation and solution
The possible problem
The power socket is
not be put well or P.S. is
damaged.
The P.S. switch
didn't work well.
There is short circuit
or fault in the machine.
When using the
battery, voltage is low or
polarity is opposite.
There is dust on
Solution
1. Confirm P.S. output
voltage is about DC
12~13V. Check whether
polarity is opposite and
mange it.
2. Check whether there is
something in the machine,
then restart. If it doesn't
work, please contact us.
1. Reload fiber.
2. Clean V-groove.
1. The length of cutting
fiber should be 16mm.
2. Push the fiber holder and
check whether there is fault
in it , then confirm its
position and manage it.
1. Clean lens and two
Lights with cotton. If it
doesn't work, contact us.
Remark
All problems
are caused by
inner circuit
fault probably.
If you couldn't
solve the
problems,
please sent it to
us with detailed
explanation.
Page 45