Promax PROLITE-40 Manual De Instrucciones página 122

Unusual condition
13.- Normal ,
setting gap and
calibration, but
splicing is
abnormal.
14.- Normal
splicing. But the
value of fusion loss
is too large and
fusion is failing.
15.- There is bubble
on the spliced fiber
or the fiber
becomes coarse or
tenuous.
Page 48
The possible problem
1. Regard "TEST"
fusion key wrongly.
2. Too large current.
3. The value of pushing is
too small or is
because of too high push
speed.
4. The board is not put
well.
1. Check whether there is
fault in system or there is
dust on the lens or lights
or reflector.
2. The value of "Setting
end-face" is too large.
3. Open the windshield
before the test.
1. The end-face of fiber is
unqualified or there is dust
on it.
2. The setting of program
parameter is wrong.
USER'S MANUAL. PROLITE-40
Solution
as 1. Confirm the fiber I sin
good condition.
2. Enter the menu to check
parameter setting and set
the proper parameter.
zero
3. Do art test until current
is proper. Reload fiber,
press to check the
fusion. If it doesn't work,
contact us.
1. Wipe the lens, reflector
and two lights; decrease
the parameter of "Setting
end-face".
2. Do arc test until the
current is proper, and then
slice the fiber. If it doesn't
work, contact us.
1. Make sure that the end
face is good. Test current
until it is proper then try
again. If it doesn't work,
change the value of "Pre-
fusion current, time" or
"Fusion push"
Remark
All problems are
caused by inner
circuit fault
probably. If you
couldn't solve
the problems,
please sent it to
us with detailed
explanation.
02-2011