Promax PROLITE-40 Manual De Instrucciones página 87

USER'S MANUAL. PROLITE-40
NOTE:
1.- To guarantee fusion target, please setting value of "Setting end-surface"
about 6.
2.- Make sure that electrode is fixed well before splicing.
3.- Make sure that electrode is well and there's no obvious injury on electrode's
top.
4.- Best to test arc each time before splicing.2 times.
Figures
(X axis or Y axis)
02-2011
Message
Reload the fiber
Bad left fiber or bad
right fiber
The picture is clear in
only one direction or
picture are unclear in
two directions.
Table 2.-
Reason
The bare fiber is
cleaved too long or too
short.
Bad end-surface's
quality.
1. There is dust in V-
groove.
2. There is dust on
bare fiber.
Measure
1. Reload fiber.
2. Recut fiber.
3. Clean the lens.
1. Remake the end-
surface.
2. Reset end-
surface's angle.
1. Clean V-groove.
2. Clean bare fiber.
3. Reload fiber.
Page 13