Promax PROLITE-40 Manual De Instrucciones página 123

USER'S MANUAL. PROLITE-40
Unusual condition
16.- The splicing 1. There is dust in V
groove.
index is too large.
(actual measure)
2. Improper current.
3. The fiber is not aligned.
4. The electrode doesn't
work well.
5.
program parameter.
6. Unqualified end face.
The cleaver is not good.
7. Special fiber.
8. Bad environment.
1.
17.- (1) The heat
LED doesn't work, damaged.
but it can heat; or
2. The heat key is stuck by
the index light
something hard.
buzzer and heater
don't work.
(2) The heat LED
and buzzer work
well, but the heater
doesn't work.
18.- Can't achieve
arc in fusion and
1. When press the
current test or
and the machine is in
something wrong
mode of auto splice,
happen.
is pressed by mistake.
2. When press
the machine is in arc test,
mistake.
02-2011
The possible problem
Improper setting of
The heat key is
and
is pressed by
Solution
1. Clean the V-groove, lens
or electrode.
2. Select proper program to
arc.
3. Adjust the cleaver.
4. If the splicing index is
too large, change the value
of "Pre-fusion current" or
"Fusion push", find proper
program.
5. Make sure that the wind
power is proper.
1. Press several
times, If it doesn't work,
contact us.
1. Don't press when
pressing the (
and the machine is in
mode of auto splice.
Remark
All problems are
caused by inner
circuit fault
probably. If you
couldn't solve
the problems,
please sent it to
us with detailed
explanation.
)
Page 49