Tension Test; Splicing Fiber And Fusion Program; Splicing Fiber; Fusion Program - Promax PROLITE-40 Manual De Instrucciones

USER'S MANUAL. PROLITE-40
5.3

Tension Test

The user can activate (ON) and off (OFF) stress test. When the user selects "1",
the splicer will check the voltage of the melting point after downloading.
5.4

Splicing fiber and fusion program

The two parameters can concert each other. You can select 20 kinds different
fusion program (SMF: 100 MMF: 100).

5.4.1 Splicing fiber

The user can select the type of fiber to merge.
The value 1 means single-mode fiber and the value 2 means multi-mode fiber.

5.4.2 Fusion program

It stands for the adopted fusion program currently. The program number is
1-100, inside it is divided to SM1-100 and MM1-100. No.1-No.5 are set by factory; you
can set program from No.6-No.100 freely. But PROLITE-40 will adjust No.6 program
after fusion testing automatically, and setup the No.6 program, please consult 8.3-arc
test. Press to enter the program setting menu after selecting program number as
right picture.
02-2011
Figure 11.-
Page 21