Franklin Electric SUBDRIVE UTILITY Manual De Instrucciones página 6

SAFETY INSTRUCTIONS
Product Specific Precautions
Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
• To minimize risk of electrical shock, disconnect power
before working on or around the system.
• Serious or fatal electrical shock may result from fail-
ure to connect the ground terminal to the motor,
drive, metal plumbing, or other metal near the motor
or cable, using wire no smaller than motor cable
wires.
• Do not use motor in swimming areas.
• Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5
MINUTES FOR DANGEROUS INTERNAL VOLTAGE TO
DISCHARGE BEFORE REMOVING COVER.
6
Risk of damage to drive or other equipment.
• Install and wire product according to the instructions
in this manual.
• Take protective measures against ESD (Electrostatic
Discharge) before touching control boards during
inspection, installation or repair.
• This product is recommended for use with Franklin
Electric 4-inch submersible motors as specified in
this manual (Refer to
page 39). Use of this unit with any other Franklin
Electric motor or with motors from other manufac-
turers may result in damage to both motor and elec-
tronics.
• In applications where water delivery is critical, a
replacement pressure sensor and/or back-up system
should be readily available if the drive fails to operate
as intended.
"Common Specifications" on