Periodic Maintenance; Fan Replacement; Screen Replacement - Franklin Electric SUBDRIVE UTILITY Manual De Instrucciones

Ocultar thumbs Ver también para SUBDRIVE UTILITY:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE

Periodic Maintenance

Periodic Maintenance

Fan Replacement

In the event that the cooling fan fails and results in an occurrence of frequent Overheated Drive
faults, the fan is replaceable. Refer to
Replacement kits.

Screen Replacement

IMPORTANT: The screen(s) should be checked occasionally and cleaned of debris to ensure proper
drive function. As the screen becomes full/blocked, the SubDrive Utility will reduce output power
to avoid excessive internal heat. This may result in reduced water delivery.
If screens are damaged or lost, replacement screens are available. Refer to
page
40.
Fan Screen: The fan screen is located on the bottom of the drive enclosure covering the fan grille.
1. Remove the center screw holding the fan screen in place (if installed).
2. Gently squeeze the retaining clips on the sides of the screen and pull away from the drive.
3. Clear debris from the plastic screen frame and metal mesh screen.
4. Reinstall the plastic screen frame. Ensure the metal mesh screen is properly retained between
the drive enclosure and plastic screen frame.
5. Reinstall the center screw and tighten to 1.5 in-lbs (0.17 Nm) (if previously installed).
Lid Screen: The lid screen is located inside the drive cover in the exhaust vent area.
1. Remove power from the drive and allow 5 minutes for internal voltage to dissipate.
2. Remove the drive cover.
3. Remove the two screen retaining screws on the outside of the lid in the exhaust vent area.
4. Remove the plastic screen retainer from the inside of the cover in the recessed exhaust vent
area.
5. Remove the metal mesh screen that is placed between the recessed exhaust vent cavity and
the plastic screen retainer.
6. Clear debris from the plastic screen retainer and metal mesh screen.
7. Reinstall the metal mesh screen and plastic screen retainer.
8. Reinstall the two retaining screws and tighten to 5 in-lbs (0.55 Nm).
9. Reinstall the drive cover.
36
"Accessories" on page 40
for information about Fan
"Accessories" on

Publicidad

Tabla de contenido
loading

Tabla de contenido