Drive Mounting - Franklin Electric SUBDRIVE UTILITY Manual De Instrucciones

INSTALLATION AND SETUP
Physical Installation

Drive Mounting

The SubDrive Utility should be mounted on a surface or backplate no smaller than the outer con-
troller dimensions in order to maintain the NEMA 3R rating. The controller must be mounted at
least 18" (45.7 cm) off the ground.
The drive is mounted using the hanging tab on the top side of the enclosure, as well as two (2)
additional mounting holes on the back side. All three (3) screw hole locations should be used to
ensure the drive is securely mounted.
IMPORTANT: Do not drill holes in the drive.
17