Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Guide
Installer setup
Follow the procedure below to configure the thermostat to match the
installed heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes.
Setup function
1
System type
TH4110D only
5
Heating cycle rate
(CPH: cycles/hour)
TH4110D only
6
Auxiliary heat
cycle rate (CPH)
TH4210D only
8
Emergency heat
cycle rate (CPH)
TH4210D only
9
Compressor
cycle rate (CPH)
13
Adaptive Intelligent
Recovery
TM
14
Temperature
display
15
Compressor
protection
69-1928EFS—01
Function
number
s
t
and
Press
Press
Press and hold
Settings & options (factory default in bold)
0
Gas, oil or electric heat with air conditioning
1
Heat pump (5 minute compressor off time in heating and
cooling)
5
For gas or oil furnaces of less than 90% efficiency
1
For steam or gravity systems
3
For hot water systems & furnaces of over 90% efficiency
9
For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
5
For gas or oil furnaces of less than 90% efficiency
1
For steam or gravity systems
3
For hot water systems & furnaces of over 90% efficiency
9
For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
9
For electric emergency heat
1
For steam or gravity systems
3
For hot water systems & furnaces of over 90% efficiency
5
For gas or oil furnaces of less than 90% efficiency
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3
Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5, or 6 CPH]
1
On **See page 8
0
Off
0
Fahrenheit
1
Celsius
5
Five-minute compressor off time **See page 8
[Other options: 0, 1, 2, 3 or 4-minute off time]
6
Setting
Setup
1
0
MCR29341
t
to change settings.
s
to advance to next function.
ts
to exit and save settings.
Publicidad
Tabla de contenido
