Inspection And Testing; Visual Inspection; Bathtub Water And Operational Test - Jacuzzi PRIMÓ Manual De Instalación

Important Safety Instructions (Cont)
Keep body and hair a minimum of 6˝ (152mm) away from the suction fitting at all times when
CAUTION
the hydromassage system is in operation. Hair longer than shoulder length should be secured
close to the head.
Do not immerse the control panel by overfilling the bath.
CAUTION
To avoid injury, use care when entering and exiting the hydromassage bathtub.
CAUTION
Do not use drugs or alcohol before or during the use of a hydromassage bathtub equipped
CAUTION
with a heater. Possible drowning may occur.
Do not use a hydromassage bathtub equipped with a heater immediately following strenuous
CAUTION
exercise.
Use this unit only for its intended use as described in this manual. Do not use attachments not
CAUTION
recommended by the manufacturers. Do not tamper with user-operated controls or such
devices.
Water temperature in excess of 104°F (40°C) may be injurious to your health. Check and
CAUTION
adjust water temperature before use.
Jacuzzi Luxury Bath ("the Company") has obtained applicable code (standards) listings generally available on a
national basis for products of this type. It is the responsibility of the installer/owner to determine specific local code
compliance prior to installation of the product. The Company makes no representation or warranty regarding, and will
not be responsible for any code compliance. Product specifications are subject to change without notice.

Inspection and Testing

Visual Inspection

Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples.
1
Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has been made.
Do not lift the bathtub by the plumbing at any time; handle by the shell only.
Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible damage to
2
any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub is installed is excluded
from the warranty. Jacuzzi Luxury Bath's responsibility for shipping damage ceases upon delivery of the products in good
order to the carrier.
Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty
3
information packed with the product or in the back of this manual.

Bathtub Water and Operational Test

All bathtub units are factory tested for proper operation and watertight connections prior to shipping. However, the unit must be
retested by the installer prior to installation. Jacuzzi Luxury Bath is not responsible for any defect that could have been discovered,
repaired, or avoided by following this inspection and testing procedure:
Place the bathtub on a level surface, near appropriate electrical supply, water supply, and water drainage. A driveway is a
1
suitable choice.
Cover the drain and overflow hole with tape or a stopper and fill the bathtub to the bottom of the overflow hole.
2
Allow bathtub to stand for 5 minutes.
3
Plug in motor/pump and turn unit on. Confirm that all features function as described in the Operation section of this manual.
4
Do not install the bathtub if bathtub fails to operate as described.
Visually inspect all joints for leaks. Do not install the bathtub if leaks are detected.
5
Return bathtub to box or otherwise protect from damage until time of installation.
6
Page 4
SAVE THESE INSTRUCTIONS.
www.jacuzzi.com
Primó™ Collection Primó™ Collection
Installation and Operation