General Operation Information; Whirlpool System; On/Off Button; Whirlpool Control - Jacuzzi PRIMÓ Manual De Instalación

Primó™ Collection

General Operation Information

All bathtubs manufactured by Jacuzzi Luxury Bath are designed for "fill
and drain," which means the bathtub should be drained after each use
and filled with fresh water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water continuously like pools
or spas.
Close the drain and fill the bathtub until water is at least 1˝ to 2˝ (25mm
to 51mm) above the highest jet or air injector (see water line indicated in
the illustration - Figure 8). Do not turn on the whirlpool or air bath system
at any time if the jets or air injectors are not completely immersed in
water. Running the whirlpool or air bath system when there is insufficient
water in the bathtub could result in water spraying outside the bath area.
Running the whirlpool or air bath system without water will damage the
recirculating pump or blower.
When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed
NOTE
out of the unit. To prevent this, you must turn unit OFF before exiting bathtub.

Whirlpool System

ON/OFF Button

Push down on the button to turn ON the whirlpool system.
Push down on the button to turn OFF the whirlpool system.

Whirlpool Control

In the closed position, the jets massage with only
water.
In the open position, air mixes with water to create a
deep, wide plume of massaging bubbles.
Fig. 10
OPEN Position
Installation and Operation
CLOSED Position
Direction (Figure 11A)
To change the direction of the water flow, swivel the jet nozzle to the
desired angle.
Water Force (Figure 11B)
Increase the force of the flow by rotating the jet face to the left
(counterclockwise).
Decrease the force of the flow by rotating the jet face to the right
(clockwise).
CAUTION
Never run the whirlpool system with all the jets closed.
Fig. 11A
Direction
www.jacuzzi.com
Fig. 8
Fill to at least 1˝ to 2˝
above highest jet
Fig. 9
ON/OFF Button
Fig. 11B
Water Force
Page 9