Cleaning; Lubrication - Sagola Mini XTREME MIX Manual De Instrucciones

24/25

12. Cleaning

When work has been completed, both the spray gun must be cleaned with the appropriate
thinner, in order to remove any remaining product.
Operate the mechanisms and spray the thinner until the application is clean. Repeat the operation
as many times as may be necessary. Remove any remains of product from the gun and cup with a
cloth soaked in thinner.
Keep air gasket areas free of accretions and foreign bodies.
The air nozzle is a precision component. Any deformation, especially in the air outlet orifices, may
cause malfunctions in its operation and incorrect or deficient quality spraying. If necessary, dip the
air nozzle in thinner in order to soften the remains of product or dirt. Once softened, blow the
nozzle with compressed air until any remains of product and thinner are eliminated.
Should it be necessary to remove the air nozzle, do this with an appropriate, soft object, with great
care and avoiding any marking or scratching.
Release the elastic ring that holds its components together.
Once disassembled, clean with thinner, using the cleaning
brush supplied.
Do not use any hard or metallic object. The blocked
orifices of the nozzle must not be cleaned with a sharp or
hard object under any circumstances.
Assemble the nozzle.
For automatic cleaning of the gun, tools and accessories
used in the mixing and preparation of the product to be
applied, we recommend the use of SAGOLA washing
machines.
IMPORTANT
The gun can be cleaned with thinners or detergents in a gun washing machine. If you opt for this
cleaning system, we advise you to remember the following considerations, which, if not applied,
may damage the gun and render the warranty null and void:
- Do not submerge the gun in solvent or detergents longer than the time required for cleaning.
- Do not use the gun immediately after cleaning has been completed.
- Ensure that there is no thinner or detergent inside and that it is completely free of these
substances. Other cleaning systems can be used (ultrasound).

13. Lubrication

The original lubrication of the gun is eliminated through
use and cleaning. In order to guarantee perfect operation,
it is necessary to grease the regulating or fastening
threads, friction areas, etc., on a periodic basis, especially
after each cleaning session and with greater care if the gun
has been cleaned in a machine. Moving parts must be
lubricated lightly after cleaning has been completed.
We recommend you to use a light SAE 10 oil or natural grease or vasoline.
It is important to check that the lubricant used does not contain components that might impair
the spraying quality (Silicones, etc.)
ENGLISH