Features And Controls - Briggs & Stratton BRUTE Manual Del Operador

Features and Controls

Read this Operator's Manual and safety rules before operating your pressure washer.
Compare the illustrations with your pressure washer, to familiarize yourself with the locations of various
controls and adjustments. Save this manual for future reference.
A
B
C
D E
,
F
G
H
J
A - Recoil Starter — Used for starting the engine
manually.
B - Oil Fill / Dipstick — Check and fill with oil here.
C - Detergent Siphoning Tube / Filter — Use to
siphon pressure washer safe detergents into the
low pressure stream.
D - Pump — Develops high pressure.
E - Automatic Cool Down System — Cycles water
through pump when water reaches 125°-155°F.
Warm water will discharge from pump onto ground.
This system prevents internal pump damage.
F - Adjustable Nozzle — Always attached to nozzle
extension. Adjustable nozzle allows you to adjust
spray pressure and spray pattern.
G - High Pressure Outlet — Connection for high
pressure hose.
H - Water Inlet — Connection for garden hose.
J - Spray Gun — Controls the application of water
onto cleaning surface with trigger device. Includes
trigger lock.
K - High Pressure Hose — Connect one end to water
pump and the other end to spray gun.
L - Fuel Tank — Fill tank with regular unleaded fuel.
Always leave room for fuel expansion.
M - Primer Bulb — Prepares a cold engine for
starting.
N - Warning/Operating Instructions Tag — Identifies
hazards and proper procedure to start/stop
pressure washer.
P - Air Filter — Protects engine by filtering dust and
debris out of intake air.
R - Throttle Lever — Sets engine in starting mode for
recoil starter and stops a running engine.
Items Not Shown:
Data Tag (near rear of base plate) — Provides
model and serial number of pressure washer. Please
have these readily available if calling for assistance.
R
P
N
M
L
K
9