Blodgett DFG-50 Manual De Instrucciones página 9

Installation
Oven Assembly
DOUBLE SECTION ASSEMBLY
NOTE: Be sure to remove the single oven flue
boxes prior to attaching the flue connector.
AC-500, DFG-100/200, CTB, Mark V, and
Zephaire E&G
1. Secure the short legs to the bottom sections.
2. Stack the ovens.
3. Place the clips over the edge of the oven
frames.
4. Bolt the clips together with 3/8" bolts and nuts
provided.
5. Attach the flue connector.
Stacking
Clips
Figure 6
DFG-50
1. Stack the ovens
2. Remove the combustion compartment cover
and side panel.
3. Align the holes in the front and rear corners of
the ovens.
4. Attach with bolts, washers and nuts as shown.
5. Replace the combustion compartment cover
and side panel.
KCO-25E
1. Secure the short legs to the bottom sections.
2. Stack the ovens.
3. Remove the bottom left and right screws from
the upper section. Remove the top left and
right screws from the lower section.
4. Attach the two stacking angles. Use the
screws removed.
5. Attach the flue connector.
Flue
Connector
Stacking
6
Figure 7
Angle
Figure 8