Cooling Unit - GYS NEOPULSE 400 G Manual De Instrucciones

COOLING UNIT

This power source can be connected to a NEOCOOL cooling unit (ref. (ref. 032750) for cooling the water torch. The recommended cooling system
unit is automatically detected by the machine. To deactivate the cooling unit, refer to the manual of the reel. For installation, refer to the cooling
unit's instruction manual.
Make sure that the cooling unit is switched off before disconnecting the inlet and outlet hoses for torch liquid.
The coolant is harmful and irritates the eyes, the mucous membranes and the skin. Hot liquid may cause burns.
CONNECTION THE INTERCONNECTION CABLE
Stop the power supply using the switch located at the front of the machine before before connecting the different cables.
Do not connect the electrode holder when using the machine in MIG / MAG mode.
• MIG / MAG (GMAW) WELDING
1
2
3
4
5
18
NEOPULSE 400 G / 500 G
REAR
3
1
2
4
5
FRONT
EN
DESCRIPTION
1 Control
2 Gas
3 Power
4
Cooling
5