Little Giant APA-05-HAR Manual Del Propietário página 3

s
DANGER
!
Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70. Failure to follow this
warning will result in property damage, personal injury or death. Do not handle a pump or pump motor with wet hands or
when standing on a wet or damp surface or in water. Failure to follow this warning can result in fatal electrical shock.
Product should only be used with liquids compatible with product component materials.
s
WARNING
!
• RISK OF ELECTRIC SHOCK - This product is supplied with a grounding conductor and/or grounding-type attachment
plug. To reduce the risk of electrical shock, be certain that it is connected to a properly grounded grounding-type
receptacle. Disconnect power before working on or around the product.
• This equipment should be installed by technically qualified personnel. Comply with national and local electrical and
plumbing codes as well as the National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA)
when installing this unit. Failure to install it in compliance with national and local electrical and plumbing codes and
within Franklin Electric recommendations may result in electrical shock or fire hazard, unsatisfactory performance, or
equipment failure. Installation information is available through pump manufacturers and distributors, or directly from
Franklin Electric at our toll-free number 888.956.0000.
• To reduce risk of electric shock, which can result in personal injury, death or major property damage if ignored, be certain
that this product is connected to a circuit equipped with a ground fault circuit interrupter (GFCI) device. Comply with all
national and local electrical and plumbing codes when installing this unit. Do not use an extension cord.
• Make certain that the unit is disconnected from the power source before attempting to service or remove any
component. If the power disconnect is out-of-sight, lock it in the open position and tag it to prevent unexpected
application of power.
• Possible cutting hazard. Rotating propeller could result in serious injury. Turn off power and lock out before
installation or servicing.
• This product has not been investigated for use in swimming pool or marine areas.
• Before attempting to install, service or maintain the unit and/or flotation in any body of water, a U.S. Coast Guard
Approved personal flotation device (PFD) type I, II or III must be worn.
• The flotation provided with this product has not been investigated for use as a personal flotation device.
• Attempting to install or service equipment from an unstable work platform could result in death or injury.
• The pump motor is equipped with an automatic-resetting thermal protector and may restart unexpectedly.
Protector-tripping is an indication of motor overloading and/or overheating. See Troubleshooting section for
additional information.
s
CAUTION
!
• Do not operate this equipment out of the water.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on product.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Follow all product wiring instructions
provided in the Electrical Connections section of this manual.
• This pump has been evaluated for use with water only.
s
NOTICE
!
• This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking
in experience and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play
with the equipment or in the immediate vicinity.
• Periodically inspect unit and system components. Schedule and perform routine maintenance as required and in
accordance with the System Maintenance section.
Do not use to pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc.
3