Careful Handling And Use Of Electrical Power Tools; Before First Use; Preparing The Tool For Use - Parkside PHP 500 B2 Instrucciones De Utilización Y De Seguridad

Safety notes / Operation
of carelessness when using the device can lead
to serious injury.
b) to avoid the danger of injury,
burning and damage to
health:
DAnGEr oF BUrnS! The glue
and the nozzle can reach tempera-
tures of 200 °C. Do not touch the
nozzle or the glue. Keep other people and an-
imals away from the hot glue. On contact with
the skin, hold the affected part under running
cold water for several minutes. Do not try to
remove the glue from the skin.
4. Careful handling and use
of electrical power tools
a) Pull the mains plug from the socket
before you make any adjustments to
the device, change accessories or when
the device is put away. This precaution is
intended to prevent you from unintentionally
starting the device.
b) When not in use always ensure that
electrical power tools are kept out of
reach of children. Do not let anyone
use the device if he or she is not
familiar with it or has not read the
instructions and advice. Electrical power
tools are dangerous when they are used by
inexperienced people. Let the device cool
down completely before putting it away. The
hot nozzle can cause damage.
c) Look after the device carefully. Check
that moving parts are working prop­
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam­
aged parts repaired before you use
the device. Many accidents have their origins
in poorly maintained electrical power tools.
d) Always work with the mains lead leading
away from the rear of the device.
26 GB/MT
operation
Q

Before first use

Q
Preparing the glue site:
D o not use inflammable solvents to clean the
glue site.
T he ambient temperature and temperature of
the materials to be glued must be not less than
+ 5° C and not warmer than + 50° C.
T he glue sites must be clean, dry and free of
grease.
S mooth surfaces should be roughened before
gluing.
W arm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.
S crew on the appropriate nozzle
the wire stand .
6

Preparing the tool for use

Q
Working with the mains lead connected:
1. Connect the mains lead
connection (see Fig. F).
10
Insert the mains plug into the mains socket.
2. Fold forward the wire stand
Stand the device up.
3. Push a glue stick into the feed channel
4. Let the device heat up for about 5 minutes.
The device is now ready for use.
Cordless working:
1. Connect the mains lead
connection .
3
Insert the mains plug into the mains socket.
2. Place the glue gun into the charger
3. Push a glue stick into the feed channel
4. Let the device heat up for about 5 minutes.
The device is now ready for use.
5. Repeat the heating­up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.
and fit
8
to the glue gun
11
.
6
.
1
to the charger
11
.
4
.
1