Troubleshooting Guide - Brita WHS-101 Instrucciones De Instalación

whole house filtration system
Test the Filter System
• Slowly turn on the water supply at
the main shutoff valve.
• Press the red pressure-relief button
on top of the Filter System to release
any trapped air.
• Check for any leaks between the
System Head and Filter Housing of
the Filter System, and on the inlet
and outlet connections. If there are
any leaks, see the troubleshooting
guide.
• Flush the Filter System for 40
minutes by keeping the nearest
faucet turned on.
8
Step 4
*
*
*
*
*
*
*
*
*
* Turn off the main water supply to your home.
* Purge all water from the plumbing lines by
turning on all faucets in your home and drain
completely.
* Tighten all fittings.
* Turn on the main water supply and inspect for
leaks.
* If leaks continue, disassemble the configured
system, reapply plumber's tape or sealant, and
reinstall the Filter System.
» If leaks continue, turn off the water supply and call
Customer Service or your local plumber.
whole house filtration system
Troubleshooting
Guide
Leaks between
system head assembly
and filter housing
Note: Place paper towels or rag under the filter
system to catch any water drips.
Turn off the main water supply to your home.
Purge all water from the plumbing lines by
turning on all faucets in your home and drain
completely.
Press the red pressure-relief button on top of
the Filter System to release pressure.
unscrew and remove the System Head from
the Filter System using the Filter Housing
Wrench.
NOTE: Use a bucket to catch any water in the
housing.
Remove the black O-Ring and inspect. Clean
and lubricate with silicone grease.
Clean the groove in the top of the filter housing
where the O-Ring sits.
Place the clean, lubricated O-Ring back in the
groove.
Screw the Filter Housing back onto the System
Head and hand-tighten. Using the Filter
Housing Wrench, tighten 1/4 turn.
NOTE: Do not over tighten.
Turn on the main water supply and inspect for
leaks.
Leaks around
fittings