Ground Connection - Allmatic IND4000V/I Importantes Instrucciones De Seguridad Para La Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MOTOR AND RACK FITTING
Predispose a cable trunking in the holes.
Follow this procedure for the installation of the backing plate:
- Bend the brackets (Fig. 5).
- Make an excavation.
- Insert the cable trunking.
- Level and cement the fixing plate.
When the backing plate is fixed, open the front cover, remove the casing from the
motor by unscrewing the screws present in the lower part of the casing.
Place the motor on the fixing plate and screw with the M12 nuts supplied (Fig.5).
The rack shall be fitted over the motor support, at a certain distance from It.
Its height can be adjusted thanks to the holes In the rack.
The height adjusting is necessary to prevent the gate leaning on the driving gear
(Fig. 6).
To fix the rack on the gate, drill some Ø 5 mm holes and thread them using an
M6 screw tap.
The driving gear needs 2 or 3 mm clearance from the rack.
LIMIT SWITCH FITTING
In order to determine the gate travel length, place two cams at the ends of the
rack (Fig. 7).
Move the cams on the rack teeth to adjust their opening and closing travel.
To fix the cams to the rack, tighten the screws issued.

GROUND CONNECTION

The system must be grounded.
Check the presence of the connection inside the box near the motor (Fig. 8).
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to
the motor has been interrupted.
Periodically, when the gate is standstill, clean and keep the guide free from stones
and dirt.
10/20
ITA
ENG
FRA
ESP
Screw for fixing casing
Nuts
Brackets
Holes for cables
Misure in mm
Ground
connection
DEU
POR
6-1624014
Nuts
Backing plate
FIG. 5
FIG. 6
FIG. 7
FIG. 8
rev.2
23/11/2015

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ind4000v/t

Tabla de contenido