Motion Detector With Image - Honeywell Le Sucre Manual Del Usuario

Motion detector with Image

Installation requirements
Install the detector:
•
In a circulation area, preferably pointing towards entrances (e.g. door, window)
•
Preferably in a corner to optimize the detection area
•
In a place where animals cannot get within 1.80 m of it by climbing on furniture,
stairs, boxes or any other object
•
In a detection area free of obstacles (e.g. curtains, wardrobes)
•
At a height of between 2.30 m and 2.50 m above the ground
Do not install the detector:
•
In a room smaller than the detection area (at least 4 m²)
•
Outdoors
•
Near a source of heat (e.g. chimney, radiator, convector, oven, cooking hob)
•
Near a source of cold air (e.g. air conditioning)
•
Opposite a window
•
Near a water point (e.g. bathroom)
Do not paint the detector
How to install
1. Using a small screwdriver, push in the housing latch
at the bottom of the sensor and remove the cover.
2. Hold the batteries in place, and pull out the battery
tab to power up the sensor. You can register the
sensor immediately or at a later time.
21