TUBES.
- Check that the water shut-off cock is open.
19. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS AT
CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
OVEN
SOSTITUTION OF THE LAMP
- Open the oven door.
- Remove the protection
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
SOSTITUTION OF THE ELECTRICAL COMPONENTS
- Remove the left panel.
- Remove the control panel
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
GAS OVEN
REPLACING THE GAS VALVE AND BURNER
CONTROL CARD.
- Remove the left panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER
- Remove inner protection
- Remove the combustion chamber.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC OVEN
REPLACING THE HEATING ELEMENT
- Remove the rear panel and disconnect the heating
element.
- Remove the interior panel
- Remove the water distributor
- Undo the screw securing the element to the oven
and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in
reverse order.
20. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
21. MAIN COMPONENTS
GAS OVEN
- Gas valve
- MAIN BURNER
- Igniter
- Spark flame control
- Control knob
- Working thermostat
- Safety thermostat
- Lamp
- Timer
- Energy regulator
- DIGITAL THERMOMETER
- engine
ELECTRIC OVEN
- Control knob
- Working thermostat
- Safety thermostat
28