Using The Tyre Inflator Gauge; Using The Blow Gun; Maintenance And Cleaning - Parkside PDSS A1 Instrucciones De Utilización Y De Seguridad

Bringing into use / Maintenance and cleaning
NOTE: The compressed air source must be fitted
with a (filter) / pressure reducer so that the air pres-
sure can be regulated.
Connect the product to a suitable compressed air
source by connecting the quick-release coupling
of the air supply hose with the plug-in nipple
the product. It locks itself in place automatically.
©
Using the tyre inflator gauge
1. Place the valve connector
Schrader valve, car tyre valve
(e.g. often used on mountain bikes)
2. Press the trigger
6
3. Release the trigger
Read off the filling pressure on the gauge
4. If the object is overfilled with air (air pressure
too high): Press the deflator valve
some air.
5. Press the lever of the valve connector
wards and pull the valve connector
valve.
6. After you finish work, disconnect the device
from the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
Using accessories:
Press the lever of the valve connector
insert the desired accessory
cap into the valve connector
9
20 GB
4
on to the valve.
5
to start the delivery of air.
to stop the delivery of air.
6
1
3 to release
down-
5
off the
5
and
5
to or the
10 13
.
5
to
Presta valve, e.g. cycle tyre valve
2
Dunlop valve, traditional cycle tyre valve
TIP: Use the valve adapter
valves shown.
©

Using the blow gun

.
1. Screw an extension nozzle
gun 7 .
2. Press the trigger
3. Release the trigger
4. After you finish work, disconnect the device
from the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
©

Maintenance and cleaning

½
WARNING!
Always disconnect the device from the compressed
air source before you clean or maintain it.
The device requires no maintenance.
½
Do not use sharp objects for cleaning the device.
for the cycle tyre
13
7
8 on to the blow
6 to start the delivery of air.
to stop the delivery of air.
6
DANGER OF INJURY!