Setting The Rear Output And Subwoofer Controller; Switching The Telephone Muting/Attenuation - Pioneer DEH-P80MP Manual De Instrucciones

Section
13 Initial Settings
1 Use Multi-Control to select Brightness.
Brightness appears in the display.
2 Push Multi-Control left or right to ad-
just the brightness level.
Each pushing Multi-Control left or right in-
creases or decreases the brightness level. 0 
15 is displayed as the level is increased or
decreased.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL) or subwoofer
(REAR SP :S/W) connection. If you switch the
rear output setting to the REAR SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in PREOUT :S/W or the auxiliary
PREOUT :FULL.
1 Use Multi-Control to select REAR SP.
REAR SP appears in the display.
2 Press Multi-Control to switch the rear
output setting.
Pressing Multi-Control will switch between
REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select REAR SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer REAR SP :S/W.
62
En
# When the rear output setting is
REAR SP :S/W, you cannot change the subwoofer
controller.
3 Push Multi-Control left or right to
switch the subwoofer output or nonfading
output (full-range RCA output).
Each pushing Multi-Control left or right will
switch between PREOUT :S/W and
PREOUT :FULL and that status will be dis-
played.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 57)
or subwoofer output (refer to Using subwoofer
output on page 57) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound is turned off, MUTE or ATT is
displayed and no audio adjustment is pos-
sible.
! Operation returns to normal when the
phone connection is ended.
1 Use Multi-Control to select Telephone.
Telephone appears in the display.