Air Distribution; Air Distribution Module Fitting - Airwell KOG 30 LN 2T Manual De Instalación Y De Mantenimiento

CHILLED WATER CASSETTE
8
8.1

AIR DISTRIBUTION MODULE FITTING

PLASTIC FACADE
Carefully unpack the module and fit the clips in the frame
corners.
For infra red models, connect the flat cable from the
receiver.
Present the frame to the unit, and apply pressure so that
the clips engage. Then screw it in place.
DIFFUSER IRYS
Carefully unpack the module.
For infra red models, connect the flat cable from the receiver.
a
ir DiStribution
install the central grille by twisting
Avoid distorsions of the frame caused by excessive
traction; the frame should be correctly centered in relation
to the false ceiling and it should especially ensure an
airtight separation between air succion and air discharge.
The seals are illustrated in the diagram below. They avoid:
After installation, check that the gap between the frame
and the suspended ceiling is less than 5 mm.
A
18
A Air by pass
B Treated air being distributed into the
suspended ceilling space.
B