Care Recommendations; Interior Cleaning; Condenser Cleaning - Sub-Zero 424G Manual Del Usuario

CARE RECOMMENDATIONS

Cleaning

INTERIOR CLEANING

To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights, control panel
and the cherrywood facing on wine racks.
Use a standard glass cleaner to clean the UV-resistant glass
door.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.

CONDENSER CLEANING

CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
Models 424G, 424FSG, 427G and 427RG
is located at the bottom of the unit, behind the kickplate. To
access, remove the kickplate. Refer to the illustration below.
Model WS-30 | The condenser is located behind the flip-
up grille. To access, pull out on the bottom edge of the grille
and rotate upward. Refer to the illustration below.
Use a soft bristle brush and vacuum to remove dust and lint
from the condenser. Clean the condenser every three to six
months.
IMPORTANT NOTE: To avoid damaging the condenser,
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
CONDENSER
Condenser (427RG shown).
| The condenser
CONDENSER
Model WS-30.
|
subzero.com 9