Pramac Powermate PMi1000 Manual Del Usuario página 49

Please comply with the following regulations:
If you need to lengthen the cable, please use the soft cable with rubber
cover (according to IEC245 or relevant requirements).
The length requirement of the lengthened cable: 60 meters for 1.5 square
millimeters one, and 100 meters for 2.5 square millimeters one. If the cable is
too long, the resistance in it will become so large that the applicable electric
power will decrease.
Keep the generator far away from other wires and cables, such as
business electricity supplying circuitry.
Warning:
The alternative AC and the direct electrical DC source can be used at the
same time. If you want to use the alternating current and direct DC current
socket at the same time, make sure that the total electric power will not exceed
the summation of alternating and direct current.
Remember! Most electrical equipment's starting power is higher than the
rating power.
Use of AC alternating current
1 Start the engine, and make sure the indicator light (green) is on.
2 Make sure that the switch of the electrical equipment to be used has been
turned off, before to plug it into the generator.
3. Start the equipement
A – Overloading indicator
light
Look out
When the electrical equipment is connected with generator, make sure the
B – Fuel alarming
indicator light
-
C - Plug
49