Faber INCA SD Serie Instrucciones De Instalación página 14

WARNING
!
When building a custom hood,
always follow all applicable codes and
standards.
The Inca SD can be used with
WARNING
!
custom cabinetry and hoods 30"
wide and up. Choose either a
When building a custom hood,
custom liner or our Standard Liner
always follow all applicable
designed for 30" and 36" wide
codes and standards.
installations.
The Inca HC SS can be used with
Liners create a perfectly-sealed,
custom cabinetry and hoods 30"
non-combustible finish for the wide and up. Choose either a
custom liner or our Standard Liner
underside of your custom/wood
designed for 30" and 36" wide
hood.
installations.
Liners create a perfectly-sealed,
The Standard Liners are made
non-combustible finish for the
up of two sections: a larger, rear
underside of your custom/wood
section (pre-cut out for insertion of
hood.
the Inca Smart) and a front section
The Standard Liners are made up of
for a total adjustable depth between
two sections: a larger, rear section
16" and 17 7/8".
(pre-cut out for insertion of the
Inca Smart) and a front section for
a total adjustable depth between
!!! IMPORTANT NOTE: YOU
16" and 17
7/8"
MUST REMOVE THE ADDITIONAL
PERFORATED SECTION
!!! IMPORTANT NOTE: YOU
AROUND THE PRE-CUT-
MUST REMOVE THE ADDITIONAL
PERFORATED SECTION AROUND
OUT WHEN INSTALLING THE
THE PRE-CUT-OUT WHEN
STANDARD LINER WITH THE
INSTALLING THE STANDARD
INCA SD MODEL.
LINER WITH THE INCA HC SS
MODEL.
Consider the shape, size, and
Consider the shape, size, and
weight of the Inca SD and Liner
weight of the Inca HC SS and Liner
to determine the configuration
to determine the configuration
of the custom/wood hood. See
of the custom/wood hood.
Range hood AND CUT-OUT
DIMENSIONS AND LINER
DIMENSIONS on Page 4.
14
FOR INSTALLATION WITH LINERS
FOR INSTALLATIONS WITH LINERS
.
1. The custom/wood hood must have a sturdy base (3/4" plywood recommended) to
accomodate the cut-out for the Inca HC SS. The base must be recessed to accomodate
1. The custom/wood hood must have a sturdy base
the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the
(3/4" plywood recommended) to accomodate the cut- bottom of the base using screws appropriate for the size and material of your custom/
wood hood. The Inca HC SS inserts into the cut-out in the Liner and base.
out for the Inca SD. The base must be recessed to ac-
2. Position the rear section of the Liner so that it abuts the back edge of your custom/
comodate the height of the Liner (see LINER DIMEN-
wood hood. Using a pen, trace the outline of the pre-cut out. Remove the Liner and
SIONS on Page 13). The Liner attaches to the
proceed to MAKE YOUR CUT-OUTS on Page 7. Install both sections of the Liner and
proceed to INSTALL THE Range hood on Page 7.
bottom of the base using screws appropriate for the
size and material of your custom/ wood hood.
The Inca SD inserts into the cut-out in the Liner and
base.
2. Position the rear section of the Liner so that it abuts
the back edge of your custom/ wood hood. Using a
pen, trace the outline of the pre-cut out. Remove the
Liner and proceed to MAKE YOUR CUT-OUTS. Install
both sections of the Liner and proceed to INSTALL
THE Range hood.
CUSTOM/WOOD
HOOD
INCA HC SS