Loading Batteries - Bushnell NatureView HD Manual De Instrucciones

INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your NatureView HD Cam, you will
first need to install a set of batteries and insert an SD card. Although that may
only take you a minute, there are some important notes about both batteries
and SD cards you should be aware of, so please take the time to read the
following directions and cautions:

Loading Batteries

After opening the two latches on the right side
of the NatureView HD Cam, you will see that the
NatureView HD Cam has twelve battery slots. For
maximum battery life, you should install a full set of
batteries. The NatureView HD Cam may also be
operated by just four batteries installed in the first
slots only (starting on the left-see photos). Battery
life will be shorter with 4 batteries, but the camera will
operate normally. If the low battery indicator blinks,
remove and reinsert the 4 batteries to resume
operation, or install a full set. Whether you use 4 or
a full set, be sure to insert each battery with correct polarity (negative or "flat"
end against the long spring of each battery slot).
Bushnell recommends using a full set of new lithium AA (Energizer
or alkaline AA batteries. NiMh Rechargeable batteries are not recommended,
as the lower voltage they produce can cause operational issues. It is also
possible to use a lead-acid external battery cell with 6V output or suitable AC
adapter-see below for more details.
Using an External Power Source
Optionally, you can connect an external 6V DC power source to the "DC
In" jack at the bottom of the NatureView HD Cam. It is recommended to
use a power source with a current output greater than 1800mA. However,
during bright daytime operation when no flash is required, the NatureView
HD Cam can function with much less current ( >400mA). Please use a
compatible power source cable (not provided) to connect the external DC
power source with the power input jack of the NatureView HD Cam,
making sure that the polarity is correct. Note: The power connector is a
4.0x1.7mm coaxial DC power plug with positive "tip" (inside pin) polarity
(Radio Shack P/N 274-1532 or equivalent).
8
WARNING:
Be sure the camera's power is switched OFF
before inserting or removing SD cards or batteries.
(optional, user provided)
brand)
®