INSTALLATION AND OWNER'S MANUAL
6.3.2
Set Temperature
When heat pump is on, short-press
surface,
symbol displays normally, Setting Œ [• temperature value twinkles, press
or
to select value, press
set up after 30 seconds, the controller will save the last setting and go back to original
surface.
6.3.3
Set Parameter
When heat pump is ON, Long-press
press
or
Status/History Fault. Short-press
press
or
When on status of Parameter Setting,
asking you to enter your code, press
confirm. When code is right,
parameter value.
When on status of Debugging,
ON or OFF.
into menu
select among Parameter Query/Parameter Setting/Debugging
to confirm your selection and switch to
select,
displays the value.
.
displays Parameter No.
displays the Number, and
47
or
into water temperature setting
to confirm and exit current setting. No any
%
displays Parameter Query,
and
display two^88_, it is
.
and
to select, press
,
to
Displays related
.
displays
.