Astralpool Elite 60 Manual De Instrucciones página 11

Besides basic operations, the AstralPoolChlore Elite electrolysis system has two inputs for voltage-free contacts, enabling the connection of
additional external controls. They are located on connector [CN7] of the unit's main circuit, on the base (Fig. 15).
The logic associated to these two inputs can be programmed during the system configuration process (see point 5.2)
[FS]
EXTERNAL FLOW DETECTOR CONTROL: input for potential-free contact. When the contact connected to this input is open

(external flow detector at rest), the electrolysis system switches off due to the flow alarm. Connect the external flow detector wiring
to the respective input [FS] on the unit's main control card.
[co]
AUTOMATIC COVER CONTROL: input for potential-free contact. Depending on the status of the contact connected to it on

the automatic cover's electric panel, this input enables you to programme a reduction of the equipment's output current to a
percentage of its nominal value.
Fig. 15
Fig. 16
Fig. 17
9