Astralpool Elite 60 Manual De Instrucciones página 8

4.3. Electrical connection of the electrolysis cell
Make the interconnection between the electrolysis cell and the power supply according to the following scheme. Due to relatively high current
intensity circulating do not modify or cut either the length or section of the supplied cables without making a previous consultation to an
authorized Astralpool distributor. The cable connecting the electrolysis cell and the power supply should never exceed the maximum length
recommended in this Manual: Elite 60 / 42353, 7.5 m.; Elite 100 / 42354, 4.0 m.; Elite 160 / 42355, 3.0 m.
4.4. Installation of the external flow detector
Besides the internal flow detector (gas detector) installed in all Astralpool Chlore equipment, the Elite range systems have an additional
mechanical flow detector (flow switch).
1. Glue the sensor holder to a section of the pipe at the entrance to the electrolysis cell. It should always be installed in a horizontal
position relative to the ground (see Fig. 4), so that the threaded inlets (1/2" - 3/8") are always accessible for the later installation of
the dosage pump injector and the ground connection (optional).
2. Install the flow detector (flow switch) supplied vertically in the sensor holder supplied with the equipment (Fig. 10).
3. There is an arrow on the head of the flow detector. Make sure that this arrow is parallel to the pipe shaft and pointing in the
direction that the water flows (Fig. 11).
4. Do not install the flow detector near magnetic objects. They could affect the operation of the magnetic device it contains and
reduce its reliability.
1.- Electrode 1 (Red)
2.- Electrode 2 (Red)
3.- Flow detector (Yellow)
Fig. 10
Fig.9b
6
Fig. 11