Description Of Rotary Switch Function; Ac Voltage Measurement - Amprobe ACDC-400 Manual De Instrucciones

4.3. DESCRIPTION OF ROTARY SWITCH FUNCTION

4.3.1. AC Voltage measurement

Maximum input for AC Voltage measurements is 600V. Do not attempt to
take any voltage measurement that exceeds the limits. Exceeding the limits
could cause electrical shock and damage the clamp meter.
V~
1. Select the " " position with the rotary selector switch.
2. Insert the test leads into the jack, the red lead into V/Ω jack, and the black lead into the
COM jack. Refer to Fig. 4.
3. Connect the test leads to the circuit, the voltage measured will be displayed with
automatic detection of the appropriate range.
4. Press R-H key you can select manually the measurement ranges in cyclic order. Press
R-H key 2 seconds to return to the AUTOMATIC range selection.
O.L
5. The " " symbol means that the measured quantity is higher than the selected
range. Press R-H key to select a higher range.
6. If reading the display is difficult, press D-H key to hold the obtained value. To exit from
this function press D-H key again.
Fig. 4: Use of clamp for AC voltage measures.
WARNING
EN - 10
ACDC-400