Continuity Test - Amprobe ACDC-400 Manual De Instrucciones

4.3.6. Continuity Test

Before taking any in circuit resistance measurement, remove power from
the circuit being tested and discharge all the capacitors.
"
1. Select the "
2. Insert the test leads into the jacks, the red lead into V/Ω jack, and black lead into COM
jack, as shown in Fig. 9.
3. Connect the test leads to the circuit, the resistance will be displayed while the buzzer
sounds when the resistance value is lower then 40Ω approximately.
Fig. 9: use of clamp for continuity measure
function.
WARNING
EN - 15
ACDC-400