Connecting To Fast Ethernet (10/100Base-Tx) Network - HP LaserJet 5100 Serie Guía De Inicio

Connecting to fast Ethernet (10/100Base-TX)
network
Use the RJ-45 port to connect the printer to fast Ethernet (10/
100Base-TX) network. (This port is only available on the HP
LaserJet 5100tn and 5100dtn printers.)
Make sure the printer is turned off before connecting to the RJ-45
Caution
port.
Figure 8
•
Connect a twisted-pair network cable to the RJ-45 port on the
HP Jetdirect print server card.
•
Connect the other end of the cable to the network.
For a successful link, either the 10 or 100 LED at the port should
Note
turn on when the printer is turned on. If no LEDs turn on, the print
server is unable to link to the network. For more information, see
the problem-solving chapter in the online use guide.
ENWW
Connecting to Ethernet 10Base-T network
start guide 23