Connect To Additional Computers On A Network - HP Deskjet F4500 All-in-One Serie Manual Del Usuario

About networking
Change the HP Deskjet from a USB connection to a
network connection
If you first install the HP Deskjet with a USB connection, you can later change to a wireless network
connection.
To change a USB connection to an integrated wireless WLAN 802.1 1 connection
Windows
1. Unplug the USB connection from the back of
the product.
2. Insert the product CD in the computer
CD-ROM drive.
3. Select Add a Device, and then follow the
onscreen instructions for a wireless network
installation.

Connect to additional computers on a network

You can connect the HP Deskjet to more than one computer on a small network of computers.
If the HP Deskjet is already connected to a computer on a network, for each additional computer you must
install the HP Photosmart Software. During installation of a wireless connection, the software will automatically
discover the product on the network. Once you have set up the HP Deskjet on the network you will not need
to configure it again when you add additional computers.
Wireless setup tips
• Insert the software CD and follow the animated setup guide.
• If you have a WPS (WiFi Protected Setup) router, then you can use Push Button Method. After the printer
has been powered on, just press and hold the WPS button on the router to establish a secure wireless
connection to your printer.
• When a wireless connection between the printer and the router has been established, the blue indicator
light on the wireless button will automatically light up.
Mac
1. Unplug the USB connection from the back of
the product.
2. Press the Wireless button to turn on the
wireless radio.
3. Turn on Airport and establish a connection
with the device.
4. Insert the product CD in the computer CD
CD-ROM drive.
5. On the desktop, open the CD-ROM and
then double-click HP Installer and follow the
onscreen instructions.
19