Compass Calibration Adjustment; Mirrors; Power Side View Mirrors - Ford Escape 2008 Manual Del Propietário

Driver Controls
7. The direction will display after
the RESET control is released. The
zone is now updated.

Compass calibration adjustment

Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.
1. Start the vehicle.
2. To calibrate, press and hold the
RESET control for approximately
ten seconds until CAL appears.
Release the control.
3. Slowly drive the vehicle in a
circle (less than 3 mph [5 km/h]) until the CAL display changes to the
direction value. It may take up to five circles to complete calibration.
4. The compass is now calibrated.
EXTERIOR MIRRORS

Power side view mirrors

Do not adjust the mirror while the vehicle is in motion.
To adjust your mirrors:
1. Rotate the control clockwise to
adjust the right mirror and rotate
the control counterclockwise to
adjust the left mirror.
2. Move the control in the direction
you wish to tilt the mirror.
3. Return to the center position to lock mirrors in place.
62
2008 Escape (204)
Owners Guide (post-2002-fmt)
USA (fus)