Attaching Safety Seats With Latch (Lower Anchors And Tethers For Children) Attachments For Child Seat Anchors - Ford Escape 2008 Manual Del Propietário

Attaching safety seats with LATCH (Lower Anchors and Tethers for
Children) attachments for child seat anchors
Some child safety seats have two rigid or webbing mounted attachments
that connect to two anchors at certain seating positions in your vehicle.
This type of child seat eliminates the need to use safety belts to attach
the child seat. For forward-facing child seats, the tether strap must also
be attached to the proper tether anchor. See Attaching safety seats with
tether straps in this chapter.
Your vehicle has LATCH anchors for child seat installation at the
following locations:
The anchors on both sides of the
center of the rear seat are provided
primarily for child seats at the
outboard seats, and are further
apart than the pairs of lower
anchors for child seat installation at
other seats. A child seat with rigid
LATCH attachments cannot be
installed at the center rear seat.
A child seat with LATCH attachments on belt webbing can be used at
the center rear seat unless a child seat at an outboard rear seat is
attached to one of these lower anchors. Install a child seat onto the
lower anchors at the center rear seat ONLY IF the child restraint
manufacturer recommends that the child seat can be installed to anchors
that are spaced up to 20 in (500 mm) apart.
Never attach two LATCH child safety seats to the same anchor.
In a crash, one anchor may not be strong enough to hold two
child safety seat attachments and may break, causing serious injury or
death.
2008 Escape (204)
Owners Guide (post-2002-fmt)
USA (fus)
Seating and Safety Restraints
145